Quick answer: Private well water in Pasco and Hernando counties can be safe to drink, but only testing tells you whether yours is. No utility samples a household well, so the job falls to the owner. The Florida Department of Health recommends testing for bacteria and nitrate at least once a year and for lead every three years. Beyond safety, Floridan Aquifer wells here commonly deliver hard water, rotten-egg sulfur odor and iron staining, and wells close to the Gulf can pick up salt. Each of those has a straightforward fix once you know what you are dealing with.
Wells are part of life once you get off the main corridors in Hudson, the rural stretches east of Spring Hill or the country around Brooksville. This guide covers how wells differ from city water, the problems we see most often in the two counties and how to check yours.
Municipal water vs. private well water: what is the difference?
City and county customers get water that has been treated, disinfected and tested by a utility, with the results published every year. Pasco County Utilities, New Port Richey, Hernando County Utilities and Brooksville all do this. A private well skips every one of those steps. The water goes from the aquifer to your pressure tank, and whatever is in it comes into the house.
That is a lot of homes. USGS water-use data for 2015 count 69,885 Pasco County residents and 37,235 Hernando County residents on household wells, about 1 in 7 and 1 in 5 of each county’s population. The Florida Department of Health’s water inventory identifies more than 10,000 Hernando County parcels known to use a private well.
Florida does not require private well owners to test, so many never do. The Florida Department of Health and UF/IFAS Extension both recommend annual testing for bacteria and nitrate, with additional tests based on what you notice: staining calls for iron and manganese tests, and an objectionable taste or smell calls for hydrogen sulfide and pH.
Where does well water come from in Pasco and Hernando counties?
Almost every well in the area taps the Floridan Aquifer, the same limestone formation that supplies the public utilities. The USGS report on Pasco County water resources found that the aquifer’s water is generally suitable for most uses, with concentrations of most constituents below drinking water limits. The exceptions it notes are the ones well owners still deal with: hard to very hard water, a few wells with high iron, and rising chloride near the coast.
Because the limestone is porous and close to the surface in many places, what happens on the land can reach the aquifer. Septic systems, fertilizer and floodwater are the usual concerns, which is why bacteria and nitrate testing sit at the top of every state recommendation.
Common well water problems around Port Richey, Spring Hill and Brooksville
1. Hard water
What you notice: white crust on faucets and shower heads, spotty dishes, soap that will not lather and a water heater that rumbles.
What causes it: calcium and magnesium dissolved from the limestone. The USGS describes Upper Floridan water in Pasco County as generally hard to very hard, above 120 mg/L, or about 7 grains per gallon and up. Well water gets no blending or treatment, so it carries the full load.
How to fix it: an Aquasential® Smart High Efficiency Water Softener, sized to your test results. If the well also has iron or sulfur, that is treated first so the softener resin stays clean. See our water softener options.
2. Hydrogen sulfide (rotten-egg odor)
What you notice: a sulfur smell, often strongest from the hot water or first thing in the morning, and tarnished silver or black stains.
What causes it: hydrogen sulfide gas occurs naturally in Floridan groundwater. Area utilities treat for it before water reaches customers; New Port Richey’s 2025 report says the city aerates its well water specifically to remove hydrogen sulfide, and Brooksville aerates as well. A private well has no such step.
How to fix it: Sulfur-Cleer® or Sulfur-OX3 systems remove the gas for the whole house. A smell only from hot water can point to a reaction in the water heater, which we check as part of the visit.
3. Iron and rust staining
What you notice: orange or brown stains in toilets, sinks and laundry, a metallic taste, or water that comes out clear and turns rusty after sitting.
What causes it: iron dissolved from the rock. The USGS Pasco study found a few wells above 300 micrograms per liter. Pasco’s own Jasmine Lakes system exceeded the 0.3 ppm secondary standard in March 2023 at 0.351 ppm before it was connected to the regional system.
How to fix it: an Iron-Cleer® or Iron-OX5 filter, ahead of the softener. Irrigation from a high-iron well is also what leaves orange stains on driveways and walls, and a filter on that line helps.
4. Bacteria (total coliform and E. coli)
What you notice: usually nothing. Bacteria rarely change how water looks or tastes, which is why testing matters.
What causes it: surface water reaching the well through a damaged casing, a poor seal or flooding, and nearby septic systems. Utility wells are not immune: Pasco’s 2023 Jasmine Lakes report recorded five E. coli-positive source samples at one well, which the county took offline until resampling came back clean. A household well with no one watching it is at greater risk.
How to fix it: find and repair the source, have the well shock-chlorinated, retest, and consider UV disinfection for ongoing protection. A reverse osmosis system with the Advanced Post Tank Filter is certified NSF P231 to reduce bacteria by more than 99.9999 percent at the kitchen tap.
5. Saltwater and high dissolved solids near the coast
What you notice: a salty or brackish taste, corrosion on fixtures, or a change over several years.
What causes it: heavy pumping near the Gulf can pull seawater into the aquifer. The USGS reported that chloride generally exceeds recommended limits near the Pasco coast, that high dissolved solids are found only near the coast, and that an upward chloride trend in a New Port Richey deep well indicated saltwater contamination. The recommended maximum for chloride in drinking water is 250 mg/L.
How to fix it: reverse osmosis is the practical answer for drinking and cooking water. Wells in Hudson, Port Richey and other coastal areas showing rising salt should also have their depth and construction reviewed.
6. Nitrate
What you notice: nothing. Nitrate has no taste, smell or color.
What causes it: fertilizer, septic systems and animal waste. Utility wells in the area test low, from 0.120 ppm in New Port Richey to 2.2 ppm in West Hernando, all under the 10 ppm limit, but a shallow private well near a septic field or pasture can test higher.
How to fix it: test annually. If nitrate is elevated, reverse osmosis or a Nitrate Reduction Conditioner treats it. Infants are most at risk, so homes with a baby on formula should test first.
How to check your well water quality
Test for bacteria and nitrate every year. That is the state’s baseline. Add lead every three years.
Test after anything changes. New taste or smell, stains, a well repair or flooding are all reasons to test right away.
Get an in-home test. Our free test checks hardness, iron, pH, total dissolved solids and chlorine at the tap in about 20 minutes, which answers most treatment questions on the spot.
Test before you buy equipment. UF/IFAS advises testing for iron and manganese before a softener is purchased and installed, because both affect what kind of system a well needs and how long it lasts. The same logic applies to sulfur: a softener alone will not fix a rotten-egg smell, and a sulfur system alone will not fix scale. A complete test up front avoids buying the wrong thing first.
Send samples to a certified lab. For bacteria, nitrate, lead, arsenic and PFAS, we arrange certified lab testing. Details are on our water testing page.
After a storm, follow county guidance. Hernando County’s emergency guidance says not to use a well that was submerged by floodwater. Once the water recedes, pump the well until it runs clear and contact the Health Department before using it for drinking or cooking.
Get local well water expertise from Culligan of Port Richey
Culligan of Port Richey has been treating private wells in Hudson, Port Richey, New Port Richey, Spring Hill, Brooksville and the surrounding communities for decades. Our technicians see the same Floridan problems every week, in different combinations from one property to the next, so we start with a test rather than a sales pitch. If treatment makes sense, we design a system around your well, from a single softener to a full iron, sulfur and UV setup, and offer both rental and purchase. Browse our well water solutions for an overview.
Ready for better well water? Schedule your free in-home water test and consultation with Culligan of Port Richey today.
Frequently asked questions about private wells in Pasco and Hernando County
How often should I test my well in Hernando County?
At least once a year for bacteria and nitrate, and every three years for lead, as the Florida Department of Health recommends. Test again after flooding, repairs or any change in taste, smell or color.
Why does my Spring Hill well water smell like rotten eggs?
Hydrogen sulfide gas forms naturally in the Floridan Aquifer. Utilities aerate to remove it, but a private well does not. A Sulfur-Cleer or Sulfur-OX3 system removes it for the whole house.
What causes orange stains if my Brooksville well water looks clear?
Dissolved iron is invisible until it meets air, then it turns to rust and stains fixtures and laundry. An Iron-Cleer or Iron-OX5 filter removes it before it reaches your taps.
Can saltwater get into wells near Port Richey?
Yes. The USGS has documented chloride above recommended limits near the Pasco coast and a rising chloride trend in a New Port Richey deep well. If your water tastes salty, test it and consider reverse osmosis for drinking water.
Is my Pasco County well safe after a hurricane?
Do not drink from a well that was underwater. Pump it until it runs clear, contact the Health Department and test for bacteria before using it for drinking or cooking.





