Can You Safely Drink the Tap Water in Myrtle Beach?

Published: November 15, 2026

Quick answer: Yes. Public water on the Grand Strand met federal drinking water standards in the most recent reports from Grand Strand Water & Sewer Authority, the City of Myrtle Beach, North Myrtle Beach and Georgetown County Water & Sewer District, and GSWSA’s 2025 report for the Bull Creek system lists no violations. That said, “meets standards” leaves room for things residents notice or worry about: chloramine disinfection, a seasonal earthy taste from algae upstream, PFAS measured above the EPA’s 2024 limit at two area plants, and whatever your own building’s plumbing adds. Water quality can vary from one house to the next, which is why a free in-home test is a better starting point than a citywide verdict.

If you live in Myrtle Beach, Conway, Surfside Beach or anywhere else on GSWSA or city water, your water is treated and tested before it enters the mains. People still ask whether it is safe, because the distance between “legal” and “exactly what I want from my kitchen tap” can be wide. Here is what homeowners across Horry and Georgetown counties should know.

What the utility’s testing does and does not tell you

The EPA regulates more than 90 contaminants in public water under the Safe Drinking Water Act, and utilities test for them on a fixed schedule. Three limits of that system matter for a Grand Strand household.

First, federal limits weigh treatment cost and available technology, not health alone, and some substances, 1,4-dioxane among them, have only an advisory rather than an enforceable limit. Second, compliance sampling describes water at the plant or a few monitoring points, not water that has traveled miles of main to a condo tower on Ocean Boulevard or a house in Carolina Forest and then through the building’s own pipes. Third, the utility’s job is safety, not aesthetics; hardness, taste and odor are outside its mandate, so a report can be spotless while the water still spots your glassware and smells like a pond in August.

Municipal water vs. private well water

Public water is treated, monitored and reported on. A private well is not; the SC Department of Environmental Services permits the drilling but does not regulate private well water quality. Inland Horry County and much of Georgetown County still rely on wells, and groundwater here can carry iron, low pH, high fluoride and sodium, and occasionally saltwater. Clemson Extension recommends well owners test for coliform, nitrate and total dissolved solids yearly. Our well water page covers the specifics; the rest of this article is about public water.

Where does Myrtle Beach’s drinking water come from?

Two rivers, and very little groundwater. GSWSA’s Bull Creek Regional Water Treatment Plant near Bucksport treats up to 45 million gallons a day from Bull Creek, a branch of the Great Pee Dee River, and its Myrtle Beach Surface Water Treatment Plant treats up to 40 million gallons a day from the Atlantic Intracoastal Waterway using conventional treatment plus ozone. According to GSWSA, the Myrtle Beach plant serves the Cities of Myrtle Beach and North Myrtle Beach, while Bull Creek water goes to GSWSA’s own customers and to Conway, Little River, Loris, Tabor City and Georgetown County WSD’s Garden City Point system. North Myrtle Beach’s 2025 report describes a blend of both plants with less than five percent from one city well. Georgetown County WSD’s Waccamaw Neck system, serving Pawleys Island and Litchfield, treats the Waccamaw River.

Horry County’s comprehensive plan notes that the county switched to surface water after the state designated the Waccamaw Capacity Use Area in 1979 because local aquifers had been depleted; GSWSA now stores treated river water in 17 deep wells for peak demand.

River water is plentiful, but it brings its own set of issues. These are the ones that come up most in our work across the Grand Strand.

1. Chloramine

What homeowners notice: A faint chemical taste, dry skin after showers, and trouble keeping aquarium fish healthy.

What causes it: GSWSA’s 2025 Bull Creek report describes its disinfectants as chloramine and chlorine, with chloramine averaging 2.73 ppm and ranging from 2.45 to 3.01 ppm against a 4 ppm maximum. The Myrtle Beach Intracoastal plant has used chloramine for years as well. Chloramine persists in long distribution systems better than free chlorine, which is exactly why utilities serving sprawling service areas choose it.

Why it matters: Chloramine is not a health concern at these levels, but it does not dissipate when a glass sits out, and it is harder to remove than chlorine; catalytic carbon is the right media.

How to fix it: An Aquasential® Smart Reverse Osmosis System removes chloramine from drinking and cooking water. A whole-house catalytic carbon filter addresses it at every tap.

2. Earthy or musty taste in summer

What homeowners notice: Water that smells like a pond or wet soil, strongest in hot showers, usually in late summer and in dry years.

What causes it: GSWSA has published a taste-and-odor notice for the Bull Creek system explaining that during extreme drought and high temperatures, algae blooming in impoundments upstream on the Pee Dee release geosmin. The utility adds powdered activated carbon at the plant to absorb it.

Why it matters: GSWSA says the water meets every EPA and SC DES standard while this happens and the compound is harmless. It is still unpleasant, and people can smell geosmin at vanishingly small concentrations.

How to fix it: Activated carbon at home does what the plant does. The carbon stages in an Aquasential RO clear it from drinking water; a whole-house carbon filter clears it from the shower.

3. PFAS

What homeowners notice: Nothing. PFAS have no taste, smell or color.

What causes it: Per- and polyfluoroalkyl substances come from industrial discharges, firefighting foam, consumer products and wastewater, and rivers collect them from everything upstream. When the state sampled every community water plant in 2020, its results showed PFOA at 6.3 ppt and PFOS at 8.2 ppt at the Bull Creek plant, PFOS at 2.7 ppt at the Myrtle Beach Intracoastal plant, and PFOA at 8.0 ppt and PFOS at 12 ppt at Georgetown County’s Waccamaw Neck plant. North Myrtle Beach’s 2024 monitoring found PFOA averaging 3.9 ppt with a high of 8.4 ppt and PFOS averaging 5.1 ppt with a high of 10 ppt.

Why it matters: In 2024 the EPA set a limit of 4 ppt each for PFOA and PFOS, with compliance phased in over several years. GSWSA’s PFAS statement says it meets all current requirements, is testing to gauge where it stands under the new rule, and is working with engineers on treatment so it can install a solution before enforcement begins. Until then, levels at the plant are what they are.

How to fix it: The Aquasential® Smart Reverse Osmosis System with Total Defense is certified to reduce total PFAS by more than 99.99 percent at the kitchen tap. For every tap in the house, the Whole Home PFAS Water Filter is certified to reduce total PFAS by more than 99 percent.

4. Lead from building plumbing

What homeowners notice: Nothing; lead cannot be seen, tasted or smelled.

What causes it: The utilities’ own numbers are low. GSWSA’s Bull Creek system reported a lead 90th percentile well under 1 ppb, North Myrtle Beach reported 0.62 ppb with no site above the 15 ppb action level, and Georgetown County WSD’s systems ranged from 0.31 to 7.4 ppb, though two systems each had one home test above 15 ppb. North Myrtle Beach and Georgetown County both completed service line inventories and found no lead service lines. The lead that shows up at a tap comes from brass fixtures, solder and fittings inside older buildings, which is why individual results vary.

Why it matters: Lead is a health risk for infants, children and pregnant women, and no sampling program covers your house specifically.

How to fix it: The Aquasential® Smart Reverse Osmosis System is certified to reduce lead by 99.7 percent. A lab test tells you whether you need it.

5. Fluoride and sodium from groundwater sources

What homeowners notice: Nothing directly, though sodium can lend a flat or salty taste at high levels.

What causes it: GSWSA adds fluoride to its river water at a dental-benefit level, averaging 0.59 ppm in 2025. Groundwater on the Grand Strand is naturally high in both fluoride and sodium: North Myrtle Beach’s single city well tested at 3.7 ppm fluoride and 270 ppm sodium, and Georgetown County WSD’s 2025 report shows three groundwater systems, Carvers Bay, Red Hill and Kilsock, above the state’s 2 ppm fluoride notification level, with sodium up to 280 ppm.

Why it matters: Fluoride above 2 ppm can mottle the developing teeth of children under nine, and the report advises alternate water for them. Sodium matters to anyone on a restricted diet.

How to fix it: Reverse osmosis reduces both at the kitchen tap.

Other things residents ask about

1,4-dioxane. GSWSA’s FAQ reports that testing with the state in 2014 found 0.18 micrograms per liter of this industrial solvent in its water, against an EPA lifetime health advisory of 200 micrograms per liter. It is not regulated, and GSWSA says it is gathering newer data.

How to check your home’s water quality

Read the report for your system. GSWSA’s reports page covers the Bull Creek system; the City of Myrtle Beach, North Myrtle Beach and Georgetown County WSD publish their own. Look at disinfectant residual, lead, fluoride, disinfection byproducts and the unregulated-contaminant table where PFAS appear. Remember that these describe the system, not your faucet.

Notice what the house is telling you. Spotting and scale point to hardness, a pool smell to chloramine, an earthy smell in August to geosmin.

Test the water at the tap. Our free in-home test measures hardness, chlorine, total dissolved solids, pH and iron on the spot. Certified lab testing is available for lead, bacteria, nitrate, arsenic and PFAS. Testing is especially worthwhile if you have just moved in, if your building is older, if you have infants or a pregnant household member, or if the taste or color has changed.

Frequently asked questions about Myrtle Beach tap water

Is Myrtle Beach tap water safe to drink right now?
Yes. The systems serving the Grand Strand met federal standards in their latest reports. PFAS measured at the Bull Creek and Waccamaw Neck plants exceed the EPA’s 2024 limit, which utilities have several years to meet; households that want to get ahead of that can use reverse osmosis now.

Why does my water smell like a swimming pool?
Chloramine, GSWSA’s primary disinfectant, at roughly 2.5 to 3 ppm. It is within limits and not a health concern, but it does not fade from a glass the way chlorine does. Catalytic carbon or reverse osmosis removes it.

Does the city soften the water?
No. GSWSA and the city systems treat for safety only. Hardness is not reported and not removed, so softening is a household decision made after a test.

Is hard water a problem on Myrtle Beach city water?
It can be, but no Grand Strand utility publishes a hardness figure and the utilities do not soften, so the answer comes from a test at your tap. Our water softener page explains what to look for.

Schedule your free water test with Culligan of Myrtle Beach

You should not have to guess about what is in your water. Culligan of Myrtle Beach has helped homeowners across Horry and Georgetown counties understand and improve their water for decades, from Little River and North Myrtle Beach through Carolina Forest, Socastee, Surfside Beach and Garden City to Murrells Inlet, Pawleys Island and Georgetown, and inland to Conway, Loris and Aynor.

Our technicians test your water, explain the results in plain language and answer your questions. If treatment makes sense, we lay out the filtration and softening options with a written quote covering rental and purchase, so you can decide what fits your home and your family.

Ready for better water? Schedule your free in-home water test with Culligan of Myrtle Beach today.

Resources for homeowners in Myrtle Beach

Schedule your free water consultation

Our Culligan water experts are ready to help you find the right solution for your water, starting with your free in-home water test and consultation.

Enter your information

Fields marked * are required fields.

By opting in, you are agreeing to receive SMS messages from Culligan. Alerts at the phone number listed above. 4 msgs/month. If you have questions, text HELP to 73777 or contact Customer Service at 1-855-558-1684 or customerservice@culligan.com. You can opt-out of the subscription anytime by texting STOP to 73777. Msg&data rates may apply. You can view the Terms and Conditions here and Privacy Policy here.